The Nano Looper 360 is a small, extremely easy to use looper with a total of 360-seconds of loop recording time. Not only that, the available 360 seconds can be divided into 11 different loops, so you get the most out of the available memory! You can think of the Nano Looper 360 as your very own "Loop Locker".

Electro-Harmonix Nano Looper 360 Controls:

• LEVEL Knob - Controls the output level of the Loop. Your dry signal remains at unity signal level from input to output. The dry signal also remains analog throughout the 360.

• LOOP Knob - Selects Loop number: 1-11. When scrolling through loops, the MEM LED flashes quickly during transitions. If the loop has no recorded memory, the MEM LED remains off. If the loop has recorded memory, the MEM LED remains on and playback can begin.

• INPUT Jack - This 1/4" jack is the audio input for the Nano Looper 360. The input impedance is 2.2Mohms.

• OUTPUT Jack - This 1/4" jack is the audio output from the Nano Looper 360. The output impedance is 470ohms.

• 9V Power Jack - Plug the output of the supplied AC adapter into the 9V power jack located at the top of the Nano Looper 360. The Nano Looper 360 draws 90mA at 9VDC with center negative plug. The Nano Looper 360 accepts Boss and Ibanez style AC adapters

• 6 minutes of loop recording time

• 11 selectable, independant Loops, that remain in memory until you erase them

• High quality, uncompressed audio: 24-bit A/D/A, 44.1kHz Sample Rate

• Intuitive looping interface

• Undo-Redo function

• Unlimited overdubbing

• Small pedal board footprint

• Optionally may use 9V Alkaline Battery, battery life: approximately 4 hours of operation (varies on conditions of use)