Effects MXR Dual Limiter Rack Module Pre-Owned

$149.00
Sold out

  • Online Layby
  • Local Pickup
  • Trusted Store
  • Worldwide Shipping
  • Serviced and Setup
Layby deposit
Layby this product by using the code LAYBY on checkout. Read our LayBy agreement.
Delivery
Standard shipping or pick up in store

Do You Have a Trade In?

Pre-owned in very good condition. 

The MXR 136 Dual Limiter hit the market sometime around late 1980 (if my detective work is correct). Even some 25 years later it is still drifting along the under currents of forum banter and the second-hand market with a small degree of notoriety. Comments often include words of praise and sometimes even prophesy about future greatness and ‘collectability’ of the MXR 136. I don’t see it becoming the next LA2A or U47, but it is certainly a nice bit of kit that has been described by a lot of people as the poor man’s Universal Audio/UREI 1176 compressor. Featuring two linkable channels for dual mono or stereo operation, the 136 certainly does offer a lot of features and a lot of character for an incredibly low price.

MXR describe the operation of the 136 in the manual as a VCA (voltage controlled amplifier) based compressor, but when you dive into the design of it there really isn’t a huge amount of similarity to the traditional DBX or SSL style of VCA compressor design. The 136 actually uses a MOSFET controlled by a 220kHz to 320kHz PWM (pulse width modulated) clock signal to chop out parts of the audio at ultrasonic speeds. The premise being that if you switch something on and off fast enough, you can ultimately control its average energy. PWM based compressor designs are shared by other compressors like the much revered Pye compressors, the Great Rivers PWM-501 and a number of devices made by Crane Song.

Feature-wise, the MXR 136 Dual Limiter has all the familiar knobs and buttons. The input and output controls allow you to push and pull the audio in and out of compression in a similar fashion to an 1176. To complement these, fully variable attack and release controls are also included to give adjustment over the compression envelope. A 4:1 to Infinity push button drastically changes the ratio from gentler compression to brick wall limiting, and a stereo link switch will share the sidechain signal between the two channels of the dual limiter. It is a little rudimentary as it doesn’t simply allow one channel of panel dials to control both channels in the compressor, but it certainly works. The back panel has XLR & TRS I/O, as well as dedicated sidechain input and output jacks for each channel. Some of these compressors shipped with pin 3 wired as hot on the XLR connectors. Something worth checking out if you do own or plan to get one – the modern standard for the last several decades is to wire XLRs pin 2 hot.

As far as built quality goes, the 136 was definitely falls under the ‘built to a budget but well put together’ category. All of the ICs are soldered directly to the PCB rather than using IC sockets, the off-board wiring is quite simple with no shielded cables for the XLR or TRS audio connectors, and the component selection is pretty stock standard. In a lot of ways it is a benefit in an older piece of gear. 7815/7915 voltage regulators, NE5532 and TL074 opamps and off the shelf potentiometers and push button switches means the 136 should be repairable and useable for another three decades.

Trustpilot
Site by White Flag